verifiedOwner-manual sourced

2010 Honda Civic Oil Capacity

1.8L 4-Cylinder (R18A1)

With filter3.9 qtViscosity5W-20Oil typeSynthetic Blend

Oil Capacity — With Filter

3.9
quarts
3.7 liters

Viscosity

oil_barrel5W-20
Synthetic Blend
With oil filter3.9 qt (3.7 L)
Without oil filter3.7 qt
Recommended viscosity5W-20
Oil typeSynthetic Blend
OEM oil filter15400-PLM-A02
Change interval7,500 mi / 12,100 km
Drain plug torque29 ft-lb (39 Nm)
verifiedSource notes: Specs on this page are sourced from owner-manual or OEM reference material.

DIY oil change essentials

Ready for your oil change?

Buy at least 4 quarts of the listed oil spec, then confirm filter fit by VIN.

open_in_newOpens Amazon

As an Amazon Associate, Oil-Capacity.com earns from qualifying purchases. Product fit, oil viscosity, and filter part numbers should be verified with the vehicle's owner's manual or parts catalog before purchase.

How to Use This Spec

1

Drain old oil completely. Reinstall drain plug, torque to 29 ft-lb.

2

Install new oil filter (OEM: 15400-PLM-A02). Pre-lubricate the gasket with clean oil.

3

Add about 3.4 quarts of 5W-20 synthetic blend oil first, then top off gradually.

4

Warm the engine, wait a few minutes, then verify oil level using the dipstick or in-vehicle oil level display if equipped. Reset the oil life monitor if equipped.

warningImportant Notes
  • • Always verify with your OEM owner's manual. Specifications may vary by trim level and production date.
  • • The drain plug gasket should be inspected and replaced if deformed.

Look Up Another Vehicle

Always verify against your OEM owner's manual. Specs may vary by trim and production date.