verifiedOEM-verified · Updated 2026

2013 Toyota RAV4 Oil Capacity

2.5L 4-Cylinder (2AR-FE)

Oil Capacity — With Filter

4.4
quarts
4.2 liters

Viscosity

oil_barrel5W-30
Synthetic Blend
With oil filter4.4 qt (4.2 L)
Without oil filter4.2 qt
Recommended viscosity5W-30
Alternate viscosity0W-20 (if 5W-30 unavailable)
Oil typeSynthetic Blend
OEM oil filter90915-YZZC2
Change interval5,000 mi / 8,000 km
Drain plug torque27 ft-lb (36 Nm)
verifiedSource: Toyota Owners Manuals & Warranties portal for 2013-2018 RAV4, maintenance data / capacities section. · Human-verified
local_gas_stationFuel Tank Capacity Research Status

We have OEM fuel tank research on file for this vehicle family, but we are not publishing a tank value for this page yet because the exact model year or configuration still needs tighter verification.

Verify each published model year or narrow the runtime year range before promotion.

How to Use This Spec

1

Drain old oil completely. Reinstall drain plug, torque to 27 ft-lb.

2

Install new oil filter (OEM: 90915-YZZC2). Pre-lubricate the gasket with clean oil.

3

Add 4.4 quarts of 5W-30 synthetic blend oil through the filler cap.

4

Run engine 30 seconds, check dipstick, top off to FULL mark if needed. Reset oil life monitor if equipped.

warningImportant Notes
  • • Always verify with your OEM owner's manual. Specifications may vary by trim level and production date.
  • • 0W-20 is approved only as a temporary alternative when 5W-30 is unavailable.
  • • The drain plug gasket should be inspected and replaced if deformed.

Look Up Another Vehicle

Or look up by VIN →

Related Tools

format_paint
Viscosity Guide
What's the best oil for your climate?
qr_code_scanner
VIN Lookup
Skip manual selection

Always verify against your OEM owner's manual. Specs may vary by trim and production date.