verifiedOwner-manual sourced

2018 Subaru WRX Oil Capacity

2.0L Turbo BOXER 4-Cylinder

With filter5.4 qtViscosity5W-30Oil typeFull Synthetic

Oil Capacity — With Filter

5.4
quarts
5.1 liters

Viscosity

oil_barrel5W-30
Full Synthetic
With oil filter5.4 qt (5.1 L)
Recommended viscosity5W-30
Oil typeFull Synthetic
OEM oil filterVerify by VIN or OEM parts catalog
Change interval6,000 mi / 9,700 km
Drain plug torqueSee owner manual
verifiedSource notes: Specs on this page are sourced from owner-manual or OEM reference material.

DIY oil change essentials

Ready for your oil change?

Buy at least 6 quarts of the listed oil spec, then confirm filter fit by VIN.

open_in_newOpens Amazon

As an Amazon Associate, Oil-Capacity.com earns from qualifying purchases. Product fit, oil viscosity, and filter part numbers should be verified with the vehicle's owner's manual or parts catalog before purchase.

How to Use This Spec

1

Drain old oil completely. Reinstall the drain plug and tighten to the torque listed in the owner manual.

2

Install a new oil filter and pre-lubricate the gasket with clean oil. If the part number is not listed in your manual, confirm it by VIN.

3

Add about 4.9 quarts of 5W-30 full synthetic oil first, then top off gradually.

4

Warm the engine, wait a few minutes, then verify oil level using the dipstick or in-vehicle oil level display if equipped. Reset the oil life monitor if equipped.

warningImportant Notes
  • • Always verify with your OEM owner's manual. Specifications may vary by trim level and production date.
  • • The drain plug gasket should be inspected and replaced if deformed.

Look Up Another Vehicle

Always verify against your OEM owner's manual. Specs may vary by trim and production date.