verifiedOwner-manual sourced

2020 Ford Explorer Oil Capacity

3.0L EcoBoost V6

Coverage: this maintenance-spec record applies to model years 2020-2024.
With filter5.7 qtViscosity5W-30Oil typeFull Synthetic

Oil Capacity — With Filter

5.7
quarts
5.4 liters

Viscosity

oil_barrel5W-30
Full Synthetic
With oil filter5.7 qt (5.4 L)
Without oil filter5.4 qt
Recommended viscosity5W-30
Oil typeFull Synthetic
OEM oil filterFL-820S
Change interval10,000 mi / 16,100 km
Drain plug torque21 ft-lb (28 Nm)
verifiedSource notes: Specs on this page are sourced from owner-manual or OEM reference material.

DIY oil change essentials

Ready for your oil change?

Buy at least 6 quarts of the listed oil spec, then confirm filter fit by VIN.

open_in_newOpens Amazon

As an Amazon Associate, Oil-Capacity.com earns from qualifying purchases. Product fit, oil viscosity, and filter part numbers should be verified with the vehicle's owner's manual or parts catalog before purchase.

Fuel Tank Capacity

18.6 gal (70.4 L)

verifiedOEM source
Capacity18.6 gal (70.4 L)

Verified for model year: 2020

Source: 2020 Explorer Order Guide

How to Use This Spec

1

Drain old oil completely. Reinstall drain plug, torque to 21 ft-lb.

2

Install new oil filter (OEM: FL-820S). Pre-lubricate the gasket with clean oil.

3

Add about 5.2 quarts of 5W-30 full synthetic oil first, then top off gradually.

4

Warm the engine, wait a few minutes, then verify oil level using the dipstick or in-vehicle oil level display if equipped. Reset the oil life monitor if equipped.

warningImportant Notes
  • • Always verify with your OEM owner's manual. Specifications may vary by trim level and production date.
  • • The drain plug gasket should be inspected and replaced if deformed.

Look Up Another Vehicle

Always verify against your OEM owner's manual. Specs may vary by trim and production date.